Arduino Projects

Enclosure design for Door locking security system (Arduino Uno & RFID)

This is an Enclosure design for the Door locking security system. We use Arduino Uno Board with six electronic Components. According to the assembling video fix all electronic Components. Use Hot glue to fix the 12v Connector and LEDs. All other components need screws. Please refer PDF for the screw information. Both covers are fitting type this snap-fit and don't use a support structure for the 3d printing.

Please follow this link for the electronic information and Programming Click here. (We are not responsible for the electronic design)

Enclosure Design for Arduino Weather Station with Circuit Diagram.

This is IP 24 rated Enclosure design for Arduino Weather Station. There have 6 electronics components and 2 covers (front & back). This is a wall mount device, waterproof (IP 24), and injection mold compatible design.  We add 2  rubber seals for the water protection one for the Rain Drop Sensor and another one is there the covers ("o" seal). The fitting type is screws fitting. The front cover has 3 transparent over-mold areas (LCD, LED & sensor). 

Please follow this link for the electronic information and Programming Click here. (We are not responsible for the electronic design)

Enclosure Design for Arduino Uno and OLED

This is a 3d printing compatible Enclosure Design for Arduino Uno Rev 3 and 0.96'' OLED Display. The Fitting type is Screw type. You can access the power port and USB port from outside.